Can decorate the family.
Strict Quality and Cost Control.
1. Don’t switch on and off the lights too often. Too frequent lighting will lead to premature blackening at both ends of the lamp, affecting the output power of the lamp, and it should be noted that it takes 5-15 minutes to restart the lamp after turning off the lamp.
2. If the voltage is very low, the two poles of the lamp will emit tungsten at the beginning of lighting, so that a lot of punctate pollutants will be produced inside the lamp, which is one of the reasons for the damage of the lamp. Therefore, it is recommended to turn on the lamp under the condition of high voltage.
3. There are many circuits for fluorescent lamps, which need auxiliary devices. Therefore, it must be used together with corresponding transformers and capacitors to ensure that the lamps start to the appropriate power.
4.pay attention to maintaining a ventilated environment, not only to take away the dust, but also to reduce the temperature of the tube, so as to extend the life of the tube.
1. The fluorescent lamp is easy to attract dust when it is hot. When it is ready to clean, turn off the power supply, and then try to let the indoor air circulate. Wipe the lamp tube gently with a twisted dry rag dipped with a little detergent, and then use a clean dry cloth to clean the detergent.
2. If conditions permit, you can use an anti-static duster to remove the dust on the surface of the lamp, and then wipe the dirt with a dry rag, not too hard.
3. According to the fluorescent lamp, clean your hands with paper towel, do not leave traces on the lamp, and usually you can use alcohol to wipe the surface of the lamp to keep clean.
Focus on providing mong pu solutions for 5 years.